Shock Absorber, Servicing

Special tools and workshop equipment required 

• Shock Absorber Set - Socket:T10001/3 
• Torque Wrench 1332 Insert - Ring Wrench - 21mm:V.A.G 1332/7 
• Counterhold - Shock Absorber - 9mm:T40255 
  Fig 1: Shock Absorber - 9Mmt40255

  Courtesy of AUDI
• Torque Wrench, 6-50Nm:V.A.G 1331A 

Shock Absorber Mount, Removing and Installing

Fig 2: Unlock The Contacts And Remove The Connector Housing

Courtesy of AUDI

• Shock absorber is removed.

Equipment versions with Electronic Damping:

-- Free up the wire on the cover.

-- Unlock the contacts and remove the connector housing from the wire. Refer to the appropriate Service Information. .

-- Remove the wiring guide from the nut.

Continuation for all:

-- Arrange the special tools as shown.

1. Shock Absorber Set - Socket:T10001/3 
2. Torque Wrench 1332 Insert - Ring Wrench - 21mm:V.A.G 1332/7 
3. Counterhold - Shock Absorber - 9mm:T40255 
4. Wire
5. Wrench
6. Torque Wrench, 6-50Nm:VAG 1331A 
7. Shock Absorber Mount

Tightening Specifications

• Refer to OVERVIEW - SUSPENSION STRUT, SHOCK ABSORBER, SPRING