Sway Stabilization Control Module 2 -J1096-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- If the Sway Stabilization Control Module 2 -J1096- is replaced, select the "Control module, replacing" program. Refer to DIAGNOSTIC ENTRIES .
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
-- Vehicles with rear axle steering; remove the rear axle steering gear. Refer to REAR AXLE STEERING GEAR, REMOVING AND INSTALLING .
-- Remove the nuts -arrows- and then remove the heat shield -1-.
-- De-energize the 48 Volt system. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Disconnect the connectors -2 and 3- and free up the wires.
-- Remove the bolts -arrows- and remove the Sway Stabilization Control Module 2 -J1096- -item 1-.