Overview - Stabilizer Bar, Without Sway Stabilization
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Always replace after removing
- 25 Nm + 90°
- Stabilizer Bar
- With rubber bushing and clamp
- The rubber bushing and clamp cannot be replaced individually
- Removing and installing. Refer to STABILIZER BAR, REMOVING AND INSTALLING, WITHOUT SWAY STABILIZATION .
- Subframe
- Nut
- Always replace after removing
- Front Upper Transverse Link
- Bolt
- Always replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION .
- 40 Nm + 180°
- Coupling Rod
- Removing and installing. Refer to COUPLING ROD, REMOVING AND INSTALLING .
- Bolt
- Always replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION .
- 40 Nm + 180°
- Nut
- Always replace after removing