Overview - Stabilizer Bar, With Sway Stabilization
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Stabilizer Bar with Sway Stabilization
- With Left Rear Suspension Stabilization Actuator -V636-
- With rubber bushing and clamp OVERVIEW - STABILIZER BAR, WITH SWAY STABILIZATION
- The rubber bushing and clamp cannot be replaced individually
- When removing and installing, do not disconnect the wiring harness from the stabilizer bar with sway stabilization
- The connector may only be disconnected if a damaged wiring harness must be replaced.
- To ensure a proper seal, the connector on the stabilizer bar with sway stabilization may only be connected and tightened once. Tightening specification: 2 Nm
- Removing and installing. Refer to STABILIZER BAR, REMOVING AND INSTALLING, VERSIONS WITH SWAY STABILIZATION .
- Bolt
- 20 Nm
- Bracket
- For the wiring harness
- Metal Nut
- 2.5 Nm
- Heat Shield
- Bolt
- 6 Nm
- Nut
- 4 Nm
- Bracket
- For Sway Stabilization Control Module 2 -J1096-
- Subframe
- Nut
- Always replace after removing
- Sway Stabilization Control Module 2 -J1096-
- Removing and installing. Refer to Sway Stabilization Control Module 2 -J1096-, REMOVING AND INSTALLING .
- Nut
- Always replace after removing
- Coupling Rod
- Removing and installing. Refer to COUPLING ROD, REMOVING AND INSTALLING .
- Bolt
- Always replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION .
- 40 Nm + 180°
- Bolt
- Always replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION .
- 40 Nm + 180°
- Clamp
- No replacement part
- A component of the stabilizer bar OVERVIEW - STABILIZER BAR, WITH SWAY STABILIZATION
- Bolt
- Always replace after removing
- 25 Nm + 90°