Upper Control Arm, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Vehicles with active suspension: pay attention to the safety precautions. Refer to SAFETY PRECAUTIONS WHEN WORKING ON VEHICLES WITH ACTIVE SUSPENSION .

-- Versions with coil springs: determine the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .

-- Versions with air suspension: determine the standard vehicle height. Refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION .

-- Remove the front wheel. Refer to WHEELS AND TIRES .

-- Install the Support Device:VAS 6931/1 -item A- to the brake rotor -1- using two wheel bolts -2-.

Courtesy of AUDI

-- Position the Engine and Gearbox Jack:VAS 6931 -item B- on the support device.

CAUTION:

There is a risk of an accident when lowering the vehicle when the engine and gearbox jack is underneath it.

- Never lower the vehicle when the engine and gearbox jack is underneath it.

- Never leave the engine and gearbox jack under the vehicle any longer than necessary.

-- Slightly lift the wheel bearing housing using the Support Device:VAS 6931/1 with the Engine and Gearbox Jack:VAS 6931 this allows the threaded connections to easily separate.

-- Loosen the threaded connection -1-.

Fig 1: Identifying Upper Control Arms And Bolts

Courtesy of AUDI

CAUTION:

Risk of damaging the wheel bearing housing by deforming it.

- Do not widen the slots in the wheel bearing housing.

-- Remove the corresponding joint pins in the upper control arm -2- from the wheel bearing housing.

-- Do not lower wheel bearing housing more than necessary.

-- Remove the bolt -4- or -3- and remove the corresponding control arm upward.