LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 187 (Front Suspension) >> 40 Front Suspension >> Stabilizer Bar >> Sway Stabilization Control Module -J924-, REMOVING AND INSTALLING >> Sway Stabilization Control Module -J924-, REMOVING AND INSTALLING, AUDI Q7/Q8, VEHICLE INTERIOR AT RIGHT A-PILLAR >> Installing

Sway Stabilization Control Module -J924-, REMOVING AND INSTALLING, AUDI Q7/Q8, VEHICLE INTERIOR AT RIGHT A-PILLAR: Installing

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Re-energize the 48 Volt system. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Complete the "Control Module, Replacing" program after replacing the Sway Stabilization Control Module Sway Stabilization Control Module -J924-, using the Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals