Sway Stabilization Control Module -J924-, REMOVING AND INSTALLING, AUDI Q7, RIGHT FRONT WHEEL HOUSING: Removing

-- If the Sway Stabilization Control Module -J924- is replaced, select the "Control module, replacing" program. Refer to DIAGNOSTIC ENTRIES .

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.

-- Remove the right front wheel housing liner rear section. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- De-energize the 48 Volt system. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Disconnect the connectors -1-.

Courtesy of AUDI

-- Remove the nuts -arrows- and free up the ground wires.

-- Remove the bolt -2- and remove the reinforcement -1-.

Courtesy of AUDI

-- Disconnect the connectors -1 and 3-.

Courtesy of AUDI

-- Remove the bolts -arrows-, pull out the bracket with the control module forward and remove.

-- Remove the bolts -arrows-, and remove the Sway Stabilization Control Module -J924- -item 2- from the bracket -1-.

Courtesy of AUDI