Stabilizer Bar, Removing And Installing, Without Sway Stabilization: Removing
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Vehicles with active suspension: pay attention to the safety precautions. Refer to SAFETY PRECAUTIONS WHEN WORKING ON VEHICLES WITH ACTIVE SUSPENSION .
TIP:
When installing, bring all cable ties back to the same position.
-- Versions with coil springs: determine the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
-- Versions with air suspension: determine the standard vehicle height. Refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION .
-- Remove the front noise insulation. Refer to OVERVIEW - NOISE INSULATION .
-- Remove the left and right nuts -arrows- and -3-.
-- Remove the left and right clamp -1- and bolt -4-.
-- Remove the stabilizer bar -2-.