Third Row Rear Belt End Fitting, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the third row rear seat backrest.
-- Unclip the cover -1- on the belt end fitting -2- -arrows- and push it upward.
CAUTION:
The spring will get bent if it is removed incorrectly. Replace the three-point seat belt if the spring gets bent.
- Move the spring -3- just far enough until it is possible to release the tab on the spring.
-- Release the spring tab -3- by inserting a small screwdriver -2- in the opening in the spring -arrow A-.
-- Push the belt end fitting -1- downward -arrow B- and disengage from the pin -4-.