Passenger Seat Occupant Detection Sensor -G128-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Make sure the connectors are pushed in all the way and that they engage audibly.
- If the instrument cluster indicates a fault in the airbag system after assembly, the DTC memory must be checked, erased, and then checked again using the Vehicle Diagnostic Tester.