Pedestrian Protection Crash Sensor -G570- / -G571-, Removing And Installing: Installing
Install in reverse order of removal and note the following:
-- Pay attention to the safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
-- Position the pressure hose -2- at the center of the color mark -4- in the recess at the specified marking -3- in the molded foam part -1-.
TIP:
- There are pressure hoses -2- without and with the color mark -4-.
- For a pressure hose -2- without a color mark -4-, measure the center and mark it.
-- Position the pressure hose evenly in both directions -arrows- in the recess in the molded foam part.
Do not kink or stretch the pressure hose.
-- Engage the pedestrian protection crash sensor into the molded foam part.
-- Install the molded foam part with the pedestrian protection crash sensors. Refer to FRONT BUMPER .
Pyrotechnical components can deploy unintentionally.
There is a risk of injury.
- Discharge static electricity by briefly touching the door striker.
-- Attach the connector -1- to the crash sensor until it clicks into place -arrow-.
-- Push in the connector lock -2- to secure the connector.
- Make sure the connectors are pushed in all the way and that they engage audibly.
- Make sure the wires are not pinched.
Risk of airbag deployment.
There is a risk of injury.
- Switching on the ignition (key/button) after assembly may only be done when the driver seat is positioned all the way back.
-- Check and erase the airbag control module DTC memory because faults can be stored from when the connectors are disconnected. Use the Vehicle Diagnostic Tester.