Component Location Overview - Passenger Occupant Detection System
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
The seat heating element is used for the passenger occupant detection system.
- Wiring Harness
- For the seat heating element with passenger occupant detection system
- Clipped in the seat pan
- Connector station in the vehicle floor under the seat.
- Removing and Installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Nut
- 1.5 Nm
- Front Passenger Seat Heating Element with Passenger Occupant Detection System Control Module -ZX14-
- The seat heating element is used for the passenger occupant detection system.
- With Right Front Seat Heating Element -Z46- and Passenger Seat Occupant Detection Sensor -G128-
- Depending on the seat version, the Passenger Seat Occupant Detection Sensor -G128- is either sewn into the cover with the seat heating element, or bonded onto the cushion
- Removing and Installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Front Passenger Seat Position Sensor -G554-
- Driver seat: Driver Seat Position Sensor -G553-
- Removing and Installing. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING .
- Bolt
- Tightening specification -item 7- OVERVIEW - SEAT POSITION SENSOR
- Wiring Harness
- For the seat position sensor/seat belt fastening detection/seat belt switch
- Clipped in the seat pan
- Connector station in the vehicle floor under the seat.
- Removing and Installing. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING .
- Passenger Occupant Detection System Control Module -J706-
- Removing and Installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
Control Module Tightening Specification on Bracket - Standard Seat
-- Tighten the screw -1- to 1.5 Nm.