Glove Compartment Handle Lock Cylinder, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the glove compartment handle. Refer to GLOVE COMPARTMENT HANDLE, REMOVING AND INSTALLING .
-- Drive out the axle -1- from the locating bore with a pin punch in the direction of the -arrow-.
-- Remove the glove compartment handle -2- with the lock cylinder.
CAUTION:
Improper handling increases the risk of destroying the lock cylinder.
The retainers and pressure springs could fall out.
- Remove and install the lock cylinder only with the key inserted correctly.
-- Insert the key -5- into the lock cylinder.
-- Carefully release the catches -1 through 4- one after the other using a small screwdriver and remove the lock cylinder -6- at the same time -arrow-.