Additional Safety Precautions For Airbag Control Module

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

After every removal and installation of the Airbag Control Module - J234-, the Guided Function "Inertial sensor basic setting" must be performed.
If the Airbag Control Module -J234- is replaced with a new part, the basic setting is performed when implementing the "15 - Replace airbag control module" program.
If the Airbag Control Module -J234- is removed and then the same one is reinstalled, perform the "inertial sensor basic setting" as follows:

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start the Diagnostic operating mode.

-- Select the Test plan tab.

-- Select the Select individual test button and select the following tree structure consecutively:

Body
Body Assembly
01 - OBD-capable systems
15 - Airbag - Airbag Control Module -J234-
15 - Airbag, Functions
15 - Basic Setting
15 - Inertial Sensor Basic Setting

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.