Lumbar Support Adjustment Motors -V125- / -V126- / -V129- / -V130-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

-- Secure the front seat to the :VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .

-- Remove the backrest seat cover and cushion. Refer to BACKREST COVER AND CUSHION, REMOVING AND INSTALLING, SEAT WITHOUT PNEUMATIC COMPONENTS .

-- Release and disconnect the connectors -1 and 2- at the lumbar support forward/back and height adjustment motors.

Courtesy of AUDI

-- Cut through the cable tie and free up the wiring harness on the lumbar support.

CAUTION:

Risk of injury due to flying metal shavings.

Irritation and injury to skin and eyes possible.

- Wear protective eyewear.

- Wear safety gloves.

-- Drill out the rivet -3-.

-- Move the lower lumbar support -1- forward, pivot it out of the backrest frame, disengage it at the top of the backrest frame -2- -arrows- and remove it.

Courtesy of AUDI