Steering Angle Sensor -G85- BASIC SETTING
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
- Steering Wheel Scales:VAS 6458A
Procedure
Select this basic setting for the following operations:
- Settings to the suspension were changed.
- The Steering Column Electronics Control Module -J527- was replaced.
- The steering column was replaced.
-- After performing the respective procedures, select the "Steering Angle Sensor - G85" program. Refer to DIAGNOSTIC ENTRIES .
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.