LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 180 (Wheels, Tires, Wheel Alignment (Tires & Wheels - Infrared System)) >> 44 Wheels, Tires, Wheel Alignment >> Axle Alignment >> Standard Vehicle Height For Axle Alignment On Vehicles With Air Suspension, Checking >> Standard Vehicle Height For Axle Alignment On Vehicles With Air Suspension, Checking, AUDI Q7 >> Dimension -a- Overview

Dimension -a- Overview

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Chassis Distance between the center of the wheel and the lower edge of the fender/wheel housing
  Front Axle Rear axle Tolerance between the right and left
Specified size. Refer to (1). Tolerance Specified size. Refer to (1). Tolerance
1BK before product improvement 442 mm ± 7 mm 454 mm ± 7 mm Less than or equal to 10 mm
1BK before product improvement 441 mm ± 7 mm 457 mm ± 7 mm Less than or equal to 10 mm
2MA before product improvement 427 mm ± 7 mm 439 mm ± 7 mm Less than or equal to 10 mm
2MB before product improvement 427 mm ± 7 mm 439 mm ± 7 mm Less than or equal to 10 mm
2MA, 2MB after product improvement 426 mm ± 7 mm 442 mm ± 7 mm Less than or equal to 10 mm
(1) The specified size is based on the standard vehicle height.
CAUTION:

Premature wear due to incorrect axle alignment.

- Only perform the axle alignment if the vehicle is at standard vehicle height.

scientia non olet · About LEMON Manuals