Rear Axle Toe, Adjusting
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Fine tooth ratchet, commercially available
Procedure
Versions without rear axle steering
-- Remove the nut -1- for the threaded connection between the tie rod/subframe. Install a new nut all the way.
-- Adjust the toe by turning the eccentric bolt -2-.
TIP:
To turn the eccentric bolt, turn the hex head at the >>top of the bolt<<.
Versions with rear axle steering:
-- Remove the nut -1- for the threaded connection between the tie rod/rear axle steering. Install a new nut all the way.
-- Adjust the toe by turning the eccentric bolt -2-.
Continuation for All Vehicles:
- Axle alignment specified values. Refer to AXLE ALIGNMENT SPECIFIED VALUES .
- The maximum adjustment range is 90° to left or right of center position.
- The geometric drive axle is automatically changed when individual toe settings are changed.
-- Tighten the nut -1-.
-- Then check the toe value again. Refer to AXLE ALIGNMENT SPECIFIED VALUES .
Tightening Specifications
- Refer to OVERVIEW - TRANSVERSE LINK