Sunroof Shade Motor -V260-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the C-pillar trim panel on the driver side. Refer to C-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- Remove the roof end strip. Refer to ROOF END STRIP, REMOVING AND INSTALLING .
-- Remove the D-pillar trim panels. Refer to D-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- Open the sun shade completely.
-- To avoid dirtying the headliner, clean the Removal Wedge:T40233 .
-- Push the Removal Wedge:T40233 between the sunroof frame -1- and the headliner.
-- Using the Removal Wedge:T40233 , loosen the headliner all the way around the sunroof frame -arrows-.
-- Disconnect the connector -1-.
Remove the bolt -arrow- and remove the Sunroof Shade Motor -V260-.