Glass Panel Seal, Removing And Installing, Front: Installing

• The vehicle and the seal must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.
• Do not stretch the seal when installing it.

-- Remove the adhesive residue from the body.

-- Clean the painted side of the adhesive surface with Cleaning Solution:D 009 401 04  and let dry.

-- Apply Bonding Agent -D 355 205 A2- -item 1- on the painted side of the adhesive surface -2- using the Applicator:D 009 500 25  -item 3- and let it dry for ten minutes.

Fig 1: Applying Bonding Agent To Adhesive Surface On Paint Side Using Applicator

Courtesy of AUDI

• If the Bonding Agent dries longer than two hours, then it must be primed again.

-- Remove the protective film from the adhesive surface.

-- Apply the seals in the opening on the glass panel.