Rear Fresh Air Blower -V80-, EMOVING AND INSTALLING, PR NUMBER 9AH, 9AQ: Installing
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Check the evaporator for debris and the corresponding seals -B- for correct bonding and damage.
-- Check the condensation water drain -arrow- for debris.
TIP
- If the Rear Fresh Air Blower -V80- and the evaporator are replaced at the same time, first install the Rear Fresh Air Blower -V80- and then the new evaporator. The foam seal on new evaporator -B- is not preformed and must first be pressed together. This is not so simple via the Rear Fresh Air Blower -V80-.
- Pressure marks on the foam seal on evaporator -B- from the Rear Fresh Air Blower -V80- are not damage. They facilitate assembly.
-- Check the connection points -A and B- (groove/spring connection) for damage.
- Damaged or improperly joined components can result in noises during operation of the A/C system.
-- Perform a basic setting for the A/C system. Refer to GENERAL INFORMATION AND PROCEDURES FOR REMOVING AND INSTALLING ADJUSTMENT MOTORS .