Component Location Overview - Relay Panel, Fuse Panel, E-Boxes, Right FOOTWELL
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Wire Junction
- Vehicles without a high-voltage system: Wire Junction -TV1-
- Vehicles with high-voltage system: Terminal 30 Wire Junction 3 -TV28-
- Removing and Installing. Refer to WIRE JUNCTION, REMOVING AND INSTALLING .
- Positive Cable
- Tightening specification: 9 Nm
- From the battery
- Connector
- Protective Diode -J201-
- Only vehicles with high-voltage system
- Removing and Installing. Refer to Protective Diode -J201-, REMOVING AND INSTALLING .
- Nut
- 9 Nm
- Line
- Allocation. Refer to the appropriate Wiring Diagram.
- Nut
- 9 Nm
- Nut
- 9 Nm
- Nut
- 9 Nm
- Nut
- 9 Nm
- Nut
- 9 Nm
- Line
- Allocation. Refer to the appropriate Wiring Diagram.
- Line
- Tightening specification: 20 Nm
- Allocation. Refer to the appropriate Wiring Diagram.
- Line
- Allocation. Refer to the appropriate Wiring Diagram.
- Line
- Allocation. Refer to the appropriate Wiring Diagram.
- Line
- Allocation. Refer to the appropriate Wiring Diagram.
- Nut
- 3 Nm
- Quantity: 2
- Main Fuse Panel
- Tightening specifications of the wires. Refer to Fig 2.
- Removing and Installing. Refer to MAIN FUSE PANEL ON BATTERY, REMOVING AND INSTALLING .
- Battery
Tightening Specification for the Main Fuse Panel
- Nut - 9 Nm
- Screw - 3.5 Nm
- Main Fuse Panel to Battery
- Nut - 9 Nm
- Nut - 9 Nm
- Battery Interrupt Igniter -N253-
- Wire - 9 Nm