Wheel Cover, Removing And Installing, Rear: Removing
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- If equipped, remove the rear wheel housing extension. Refer to WHEEL HOUSING EXTENSION, REMOVING AND INSTALLING, REAR .
-- Loosen the rear wheel housing liner from the retainer in the bumper cover area. Refer to REAR WHEEL HOUSING LINER, REMOVING AND INSTALLING .
-- Release the catches -arrows- using needle nose pliers between the side panel mount -4- and the bumper cover -3-, and at the same time remove the wheel cover -2- from the bumper cover.
-- Carefully warm up the wheel arch trim using the Hot Air Blower:V.A.G 1416 .
-- Pry up the wheel cover with the Wedge Set :T10383/1 from the side panel -1- at the same time do not damage the paint coat.