Wheel Cover, Removing And Installing, Rear: Installing

Install in the reverse order of removal while noting the following:

• The vehicle and the cover must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.

-- Remove the adhesive residue from the body.

-- Clean the painted side of the adhesive surface with Cleaning Solution and let it dry.

-- Fold back the end of the protective film, or attach a pulling aid -4- to the protective film.

Courtesy of AUDI

-- Remove the protective film on the pulling aids from the adhesive tape -3-.

-- Position the wheel cover -5- starting at the side panel -1- to the bumper cover -2-.

-- Press the wheel cover on until it clicks into place.

-- Press on the wheel arch trim in the area of the adhesive surface with the Roller :T40400  .

• Vehicle resting time is at least 60 minutes at room temperature.