Washer Fluid Line Hose Connections, Disconnecting And Connecting

Various hose couplings are used to connect the hoses to the washer fluid pumps and spray jets or as coupling points.

Unsecured Hose Coupling

Fig 1: Identifying Unsecured Hose Coupling

Courtesy of AUDI

-- To disconnect the connection, pull both parts of the coupling apart.

-- To connect, press both parts of the coupling together firmly until they noticeably engage.

Secured Hose Coupling with Circlip

Fig 2: Connecting/Disconnecting Washer Hose Coupling (Type 1)

Courtesy of AUDI

-- To disconnect the connection, turn the circlip -1- 90° in the direction of -arrow- and remove the hose connector.

-- To connect, attach the hose connector and turn circlip -1- in the direction of -arrow- until it engages.

Secured Hose Coupling with Clip, Version 1

Fig 3: Connecting/Disconnecting Washer Hose Coupling (Type 2)

Courtesy of AUDI

-- To disconnect the connection, pull clip -1- up approximately 1 mm in the direction of -arrow- and remove the hose connector.

-- To connect, attach the hose connector and press the clip in until it engages.

Secured Hose Coupling with Clip, Version 2

Fig 4: Connecting/Disconnecting Washer Hose Coupling (Type 3)

Courtesy of AUDI

-- To disconnect the connection, pull clip -1- up in the direction of -arrow- and remove the hose connector.

-- To connect, attach the hose connector and press the clip in until it engages.

Headlamp Washer System Hose Connection with Clip

Fig 5: Connecting/Disconnecting Washer Hose Coupling (Headlamp Washer System)

Courtesy of AUDI

-- To disconnect the connection, press clip -1- -arrow- and remove the hose connector.

-- To connect, hold the clip pressed -arrow- and attach the hose connector.

-- Make sure the connection is engaged securely by pulling on the hose without pressing the clip.

Headlamp Washer System Hose Coupling with Clamp

Fig 6: Headlamp Washer System Hose Connection With Hose Clamp

Courtesy of AUDI

-- To disconnect the hose clamp connection -1-, cut with side cutting pliers and remove the hose connector.

-- To connect, slide the new hose clamp onto the hose, attach the hose connector and install the hose clamp with Hose Clamp Pliers:VAG1275  .

Headlamp Washer System Hose Connection with Spring Clip

Fig 7: Headlamp Washer System Hose Coupling With Spring Clamp

Courtesy of AUDI

-- To disconnect the connection, open spring clamp -1- with Hose Clip Pliers:VAG1921  and remove the hose connector.

-- To connect, open the spring clamp with Hose Clip Pliers:VAG1921 :VAG1921  and attach the connector.