Evaluating Test Results
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Evaluating the battery test results for the Warranty and Service Tests
| Battery Test Result | Measure |
|---|---|
| Battery good | No measure on the battery |
| Battery good - recharge | Charge battery. Refer to BATTERY, CHARGING . If necessary, search for the cause of the discharging |
| Perform a current draw test | Perform a current draw test. Refer to CURRENT DRAW TEST . Charge the battery completely and test again. Refer to BATTERY, CHARGING . |
| Replace the battery. | Disconnect the battery and test again. The result "replace the battery" can occur due to a weak cable contact. |
| Battery cell faulty - replace | Replace the battery. |
| Connection, Checking | Connect the cable directly to the battery and not to the battery jump start terminal. |
| Battery depleted | Replace the battery. |
Evaluating the Battery Test Results for the Maintenance Test
| Battery Test Result | Measure |
|---|---|
| Battery good | No measure |
| Charge the battery immediately. | Fully charge the battery. Refer to BATTERY, CHARGING . |
| Mark as defective | Mark as defective. |
| Tester Connection, Checking | Disconnect the battery and test again. The result "check the tester connection" can occur because the cable contact is weak. |
| Connection, Checking | Connect the cable directly to the battery and not to the battery jump start terminal. |
| Noises | Wait until the measured value appears in the display. |
| Battery depleted | Replace the battery. |