Brake Pad Wear Indicator Wire, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Check the brake pad wear indicator contact for damage and replace if necessary.
- Make sure that the brake pad wear indicator contact fits correctly in the brake pad.
-- Insert the contact -3- for the brake pad wear indicator with the clip -4- until it engages in the inner brake pad.
-- Secure the brake pad wear indicator wire with the dust cap -2- and the clips -1 and 5-.
-- Bring the connector -1- into its installation position and turn in the direction of -arrow- until the tab -3- engages in the hole -4- on the bracket.
-- Connect the connector -2-.
- Make sure that the wire is routed correctly.
- Make sure the wire is not blocked, bent, or rubbing against the vehicle.