Overview - Transmission Mount
WARNING: This page is about a different car, the 2024 Audi SQ7 and 2023 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
- Mount
- For the side transmission mount
- Side Transmission Mount
- Transmission Mount Valve 1 -N262- right
- Transmission Mount Valve 2 -N263- left
- Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
- Bolt
- 20 Nm
- Side Transmission Support
- Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
- Bolt
- 55 Nm
- Bolt
- Tightening specifications. Refer to the appropriate Service Information .
- Tunnel Crossmember
- Removing and Installing. Refer to the appropriate Service Information .
- Bolt
- 40 Nm
- Nut
- Only remove when the transmission mount must be separated from the transmission support
- 20 Nm
- Rear Transmission Support
- Removing and installing. Refer to REAR TRANSMISSION MOUNT, REMOVING AND INSTALLING .
- Rear Transmission Mount
- Removing and installing. Refer to REAR TRANSMISSION MOUNT, REMOVING AND INSTALLING .
- Stop
- For the rear transmission mount
- Bolt
- Only remove when the transmission mount must be separated from the transmission support
- Always replace after removing
- 20 Nm +90°
- Nut
- 20 Nm
- Bolt
- 10 Nm
- Heat Shield
- Washer
- Bolt
- 55 Nm
- Bolt
- 20 Nm