Rear Axle Steering Gear, Moving Into Zero Position
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
An angle up to 4.8° is still possible when the vehicle is stationary. Therefore, the rear axle steering gear must be brought into the zero position before an axle alignment or before calibrating any driver assistance systems.
- This is the only way to ensure that the rear axle steering is in the straight-ahead position.
-- Select the "Rear Axle Steering Gear, Moving into Zero Position" program. Refer to DIAGNOSTIC ENTRIES .
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.