Reflector, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- The vehicle and the reflector must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Clean the plastic side of the adhesive surface with Cleaning Solution:D 009 401 04 and let dry.
-- Apply Plastic Primer on the plastic side of the adhesive surface and let dry until the solvent has completely evaporated.
- Apply the reflector within 60 minutes.
-- Remove the protective film from the adhesive tape -3 and 4-.
-- Position the reflector -2- and press it onto the bumper cover -1-.
- Resting time approximately 30 minutes at room temperature