Near Field Communication Antenna 2 -R351-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

-- Using the Removal Tool for Coupling - Aerial:T40388 -A-, carefully push the rubber lip on the Near Field Communication Antenna 2 -R351- to the side and guide in the Removal Tool for Coupling - Aerial:T40388 vertically from above as shown.

-- The catch -2- is released and engages in the groove on the Removal Tool for Coupling - Aerial:T40388 -A-.

-- Pull the Removal Tool for Coupling - Aerial:T40388 -A- back out vertically upward and remove the Near Field Communication Antenna 2 -R351- -1- from the storage compartment.

-- The Near Field Communication Antenna 2 -R351- is attached to the opposite side. Tilt the Near Field Communication Antenna 2 -R351- -1- out of the storage compartment.

-- Release and disconnect the connectors from the Near Field Communication Antenna 2 -R351- -1-.