Alcohol Interlock System, Removal
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Pay attention to the manufacturer instructions.
Removing
-- Connect the Vehicle Diagnostic Tester.
-- Select "flash".
-- Select "Enter SVM code".
-- Perform the software update with SVM code -46A610-.
-- Switch off the ignition.
-- Remove a 20 A fuse in Fuse Panel J -SJ- from location SJ9 in the luggage compartment on the left side.
-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .
-- Remove the alcohol interlock system control module and handheld from the glove compartment.
-- Remove the wires from the glove compartment, secure them to the bulkhead and insulate them.
-- Remove the grommet, close holes in the glove compartment with fitting plugs.
-- Install the glove compartment.