Cylinder Bank 1 (Right) Camshaft Housing, Removing And Installing: Removing
WARNING: This page is about a different car, the 2022 Audi Q8, 2021 Audi Q8, 2020 Audi Q8, and 2019 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the right coolant pipe from the longitudinal member. Refer to RIGHT COOLANT PIPES ON LONGITUDINAL MEMBER, REMOVING AND INSTALLING .
-- Loosen the hose clamp -1- and disconnect the hose for the EVAP system.
-- Seal the open lines and connections with clean plugs from the : VAS6122 .
All other procedures are described. Refer to CAMSHAFT HOUSING, REMOVING AND INSTALLING .