Wiring Harness Repair Set - Hot Air Blower :VAS1978/14A

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Hot Air Gun (VAS 1978/14)

Courtesy of AUDI

CAUTION:

When heat-shrinking crimp connections, be careful not to damage any other wiring, plastic parts or insulating material with the hot nozzle of the hot air gun.

Always observe operating instructions of heat gun.

The Wiring Harness Repair Set - Hot Air Blower :VAS1978/14A is used together with the Wiring Harness Repair - Blower - Shrink Element:VAS1978/15A to heat-shrink the crimp connectors. After crimping, crimp connections must be heat-shrunk using hot air gun to prevent moisture penetration.

The Wiring Harness Repair Set - Hot Air Blower :VAS1978/14A is a component of the Wiring Harness Repair Set:VAS1978B and its previous versions.

Fig 2: Heating Crimp Connection Using Hot Air Gun

Courtesy of AUDI

-- Insert the Wiring Harness Repair - Blower - Shrink Element:VAS1978/15A on the Wiring Harness Repair Set - Hot Air Blower :VAS1978/14A .

CAUTION:

Risk of damaging surrounding components.

When heat-shrinking crimp connections, be careful not to damage any other wiring, plastic parts or insulating material with the hot nozzle of the hot air blower.
Always observe operating instructions of heat gun.

-- Heat crimp connection using hot air gun lengthwise from center outward until it is sealed completely and adhesive comes out the ends.

Fig 3: Identifying Single Crimp Connection

Courtesy of AUDI

This is how the completed repair location with individual crimp connector should appear.