Flat Connector Systems

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts. Refer to SECONDARY LOCK .

Flat Connector System with One Retaining Tab

Fig 1: Identifying Removal Of Flat Connector Terminal With One Retaining Tab (1 Of 2)

Courtesy of AUDI

-- Guide the release tool which fits the connector housing into release channel on connector housing.

-- Grasp contact at wire and push it gently into connector housing in direction of -arrow-.

NOTE:

By pushing the contact in the direction of the connector housing, the contact retaining tab is lifted off the housing shoulder and can be released using the release tool.

-- At the same time, push the release tool in the direction of the connector housing and pull the released contact out of the connector housing in direction of -arrow-.

Fig 2: Identifying Removal Of Flat Connector Terminal With One Retaining Tab (1 Of 2)

Courtesy of AUDI

-- After removing the contact, release tool can be pulled out of the connector housing again.

Flat Connector System with Two Retaining Tabs

Fig 3: Identifying Removal Of Flat Connector Terminal With Two Retaining Tab (1 Of 2)

Courtesy of AUDI

-- Guide the release tool which fits the connector housing into release channel on connector housing.

-- Grasp contact at wire and push it gently into connector housing until it stops in the direction of -arrow-.

NOTE:

By pushing the contact in the direction of the connector housing, contact retaining tabs are lifted off the housing shoulder and released using the release tool.

-- At the same time, push the release tool in the direction of the connector housing and pull the released contact out of the connector housing in the direction of -arrow-.

Fig 4: Identifying Removal Of Flat Connector Terminal With Two Retaining Tab (1 Of 2)

Courtesy of AUDI

-- After removing the contact, release tool can be pulled out of the connector housing again.

Asymmetrical

Fig 5: Identifying Removal Of Asymmetrical Flat Connector Terminal (1 Of 2)

Courtesy of AUDI

-- Guide the release tool which fits the connector housing into release channel on connector housing.

-- Grasp contact at wire and push it gently into connector housing in the direction of -arrow-.

NOTE:

By pushing the contact in the direction of the connector housing, contact retaining tabs are lifted off the housing shoulder and released using the release tool.

-- At the same time, push the release tool in the direction of the connector housing and pull the released contact out of the connector housing in the direction of -arrow-.

Fig 6: Identifying Removal Of Asymmetrical Flat Connector Terminal

Courtesy of AUDI

-- After removing the contact, release tool can be pulled out of the connector housing again.