Removing Insulation From The Shield

Fig 1: Identifying Locking Pin -1-, Antenna Wire And Locking Pin -3-

Courtesy of AUDI

-- Push the locking pin -1- all the way into the rotating cutting piece.

-- Push the antenna wire -2- all the way into the rotating cutting piece. The locking pin -3- can not be seen completely.

Fig 2: Push Antenna Wire All The Way Into Rotating Cutting Piece

Courtesy of AUDI

-- Push the blade holder -1- against the axle of the rotating cutting segment until it locks into place. The gap -2- under the blade holder is completely closed.

-- Hold the antenna wire so that it cannot turn.

-- Turn the rotating cutting segment -3- 2 times in direction of -arrow- until it starts to turn easily.

Fig 3: Identifying Locking Pins

Courtesy of AUDI

-- Pull the release pin -1-. The blade holder unlocks and separates from the antenna wire.

-- Push the locking pin -2- all the way into the rotating cutting piece. The antenna wire is pushed out of the rotating cutting segment.

-- Remove insulation from the antenna wire.

-- Remove any insulation remaining on the rotating cutting segment.