Crimping Outer Conductor

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Crimping Outer Conductor

Courtesy of AUDI

-- Slide the sleeve -2- and outer contact -1- over the inner conductor. The knurled contact piece must be pushed under the shield, but over the aluminum foil.

-- Slide on the outer contact piece -3- all the way. Make the bushing/pin fit correctly when doing this.

-- Push the sleeve -2- up to the outer contact.

Fig 2: Crimping Outer Conductor

Courtesy of AUDI

-- Open the tool and fold out the positioner -1-.

-- Position the antenna wire -3- with the outer contact -2- attached, into the center profile at the contact edge of the tool head.

-- Close the tool then open it again.

-- Remove the antenna wire -3-.