Overview - Sound System, Premium Sound System, 9VS, Before Product Improvement
The Premium Sound System consists of the following components:
- Two speakers in the left and right A-pillars
- Two speakers in the left and right front doors
- One speaker on the left and right side of the instrument panel
- Two speakers in the center of the instrument panel
- One speaker in the left and right B-pillars
- One loud speaker in the left and right rear doors
- One speaker in the right and left rear of the roof
- Subwoofer -R211- in the luggage compartment
- Center Speaker -R208- in the Center Instrument Panel
- Digital Sound System Control Module -J525- in the luggage compartment or behind the left rear bench seat on the crossmember
- Digital Sound System Control Module -J525- in the luggage compartment or behind the left rear bench seat on the crossmember
- Left Front Treble Speaker -R20- /Right Front Treble Speaker -R22- at the top of the A-pillars, at height of the exterior rearview mirror
- Left Front Midrange Speaker -R103- /Right Front Midrange Speaker -R104- in the front doors
- Left Front Speaker -R2- /Right Front Speaker -R3- in the instrument panel on the left and right sides
- Left Rear Treble Speaker -R14- /Right Rear Treble Speaker -R16- Inside the B-Pillars
- Left Rear Bass Speaker -R15- /Right Rear Bass Speaker -R17- at Bottom of the Rear Doors
- Left Front Bass Speaker -R21- /Right Front Bass Speaker -R23- in the Lower Front Doors
- Left Front Treble Speaker 2 -R220- /Right Front Treble Speaker 2 -R221- in the A-pillars at the top
- Left Effects Speaker -R209- /Right Effects Speaker -R210- in the rear of the roof
- Center Speaker -R208- in the Center Instrument Panel
- Center Speaker 2 -R219- in the Center of the Instrument Panel
- Subwoofer -R211- in the luggage compartment
- Interior Microphone -R74- in Front Roof Module -WX3-
- MOST Bus
Fault Finding is performed using the "Guided Fault Finding" on the Vehicle Diagnostic Tester .
Notes on MOST bus
The optical data bus "MOST bus" is used in addition to the CAN bus.
A fiber-optic cable is used. Fiber optic cables are routed inside corrugated tubes for protection.
Replace the complete fiber-optic cable if possible.
The front surface of the connectors must not be contaminated.
If the connectors are disconnected: connect the Fiber-Optic Repair Set - Connector Protective Caps:VAS 6223/9 from the Fiber-Optic Repair Set:VAS 6223A .
When routing fiber-optic cables, make sure not to go below the minimum bending radius of 25 mm. Do not crush or kink fiber optic cables.
Fiber-optic cable repair. Refer to FIBER-OPTIC CABLES, REPAIRING .