Left Rear Information Display Control Head Control Module -J648- /Right Rear Information Display Control Head Control Module -J649-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

-- Remove the backrest cover and cushion. Refer to BACKREST COVER AND CUSHION, REMOVING AND INSTALLING .

-- Carefully push the Left Rear Information Display Control Head Control Module -J648- -1- in the direction of the -arrow A- from the upper eye on the backrest frame.

Courtesy of AUDI OF AMERICA, LLC

-- Then pull the Left Rear Information Display Control Head Control Module -J648- -1- in the direction of the -arrow B- from the lower eye on the backrest frame.

-- Release and disconnect the connector -2- from the Left Rear Information Display Control Head Control Module -J648- -1-.

-- Unclip the wires from the Left Rear Information Display Control Head Control Module -J648- -1-.

-- Remove the Left Rear Information Display Control Head Control Module -J648- -1-.