Chip Card Reader Control Module, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.
-- Open the glove compartment.
-- Remove the chip card from the Chip Card Reader Control Module -J676-.
-- Slide the Chip Card Reader Control Module -J676- -1- back -arrow- until it can be removed from the trim.
-- Release and disconnect the connectors from the Chip Card Reader Control Module -J676- -1-.
-- Remove the Chip Card Reader Control Module -J676-.