LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 147 (Communication (Infotainment System - Online Services)) >> 91 Communication >> Infotainment System >> Overview - Infotainment System >> Overview - Infotainment System, From My 2021

Overview - Infotainment System, From My 2021

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

On the Infotainment system, the following functions are integrated in the Information Electronics Control Module 1 -J794- :

Optional

GWWA91-13476Courtesy of AUDI OF AMERICA, LLC
  1. Front Information Display Control Head 2 -J1060-, in the front center console
  2. Front Information Display Control Head -J685- in Center of the Instrument Panel
  3. DVD Player -R7- in glove compartment
  4. Driver Volume Control -E67-
  5. Information Electronics Control Module 1 -J794- behind the glove compartment
  6. Mobile Device Charger 1 -J1146- in the front center console storage compartment
  7. USB Distributor -R293- in the front center console storage compartment
  8. USB Connection 1 -U41- in the rear center console trim
  9. Digital Sound System Control Module -J525- in the luggage compartment / behind the rear bench seat
  10. Sound Systems
  11. TV Card Reader -R204- in the luggage compartment on the right rear side
  12. TV Tuner -R78- in the right rear of the luggage compartment
  13. MOST Bus
  14. Instrument Cluster Control Module -J285-

The MOST bus performs the system data exchange in the CAN bus and MMI.

Fault Finding is performed using the "Guided Fault Finding" on the Vehicle Diagnostic Tester .

Notes on MOST bus

The optical data bus "MOST bus" is used in addition to the CAN bus.

A fiber-optic cable is used. Fiber optic cables are routed inside corrugated tubes for protection.

Replace the complete fiber-optic cable if possible.

The front surface of the connectors must not be contaminated.

If the connectors are disconnected: connect the Fiber-Optic Repair Set - Connector Protective Caps:VAS 6223/9  from the Fiber-Optic Repair Set:VAS 6223A  .

Fig 1: Fiber-Optic Conductor Repair Set VAS 6223A
GWWW00-11495Courtesy of AUDI OF AMERICA, LLC

When routing fiber-optic cables, make sure not to go below the minimum bending radius of 25 mm. Do not crush or kink fiber optic cables.

Fiber-optic cable repair. Refer to FIBER-OPTIC CABLES, REPAIRING .