Rear Pull Handle, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the door trim panel. Refer to REAR DOOR TRIM PANEL, REMOVING AND INSTALLING .
-- Place the door trim panel on a soft surface.
-- Remove the insulation mat.
-- Disconnect the connectors at the rear of the door trim panel.
-- Remove the bolts -arrows-.
-- Remove the pull handle with the armrest -1- from the door trim panel.
-- Unclip the switch mount -1- from the pull handle with the armrest -2- using the :T10383/1 -arrow- and remove it.