Rear Lid Upper Trim Panel, Removing And Installing

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Pry Lever:80-200
Omega Clip Tool:T40280

Upper Trim Panel, Removing

Fig 1: Releasing Hooks With A Screwdriver -Arrow A-

Courtesy of AUDI

-- If installed, unclip the cap with a screwdriver -arrow A- and remove the screw behind it.

-- Unclip the upper trim panel -2- from the side trim panel -A arrow- using the :80 - 200 .

Courtesy of AUDI

-- Unclip the rest of the trim panel clips and remove the trim panel.

Side Trim Panel, Removing

-- Remove the rear lid lower trim panel. Refer to REAR LID LOWER TRIM PANEL, REMOVING AND INSTALLING .

-- Unclip the side trim panel -1- from the rear lid -arrow B- using the :80 - 200 .

-- Unclip the rest of the trim panel clips and remove the trim panel.

Installing

Install in reverse order of removal.