Differential Lock Control Module -J187-, REMOVING AND INSTALLING, AUDI Q7 AND Q8 WITH "quattro sport"

• The ignition is off.

-- Remove the luggage compartment floor covering.

-- Unclip the Differential Lock Control Module -J187- -1- from the bracket.

Fig 1: Differential Lock Control Module -J187-, Vehicles with Final Drive 0BX "quattro sport"

Courtesy of AUDI

-- Release the connector -A- and disconnect it from the Differential Lock Control Module -J187-.

-- The Differential Lock Control Module -J187- is installed in the reverse order.

• If the Differential Lock Control Module -J187- was replaced, then additional work is necessary. Refer to ADDITIONAL WORK AFTER REPLACING Differential Lock Control Module -J187- .