All-Wheel Drive Pump -V415-, REMOVING AND INSTALLING, 0D3 AND 0BX: Removing
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- The hydraulic pump -A- is installed inside the hydraulic control unit. Assembling the hydraulic pump. Refer to Figure.
- The adapter -B- is installed in the recesses in the hydraulic pump.
- A new O-ring -D- is on the All-Wheel Drive Pump -V415-.
-- Insert the All-Wheel Drive Pump -V415- with the coupling -C- into the adapter -B-.
-- Diagonally tighten the four bolts on the All-Wheel Drive Pump -V415- -2- to the tightening specification OVERVIEW - HYDRAULIC CONTROL UNIT 0D3 AND 0BX.
-- Connect the connector -1- to the All-Wheel Drive Pump -V415-.
-- Fill the ATF in the rear final drive. Refer to ATF, FILLING, 0D3 AND 0BX "quattro sport" .