Oil Spray Jets, Removing And Installing: Removing
WARNING: This page is about a different car, the 2022 Audi Q8, 2021 Audi Q8, 2020 Audi Q8, and 2019 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the oil tray. Refer to OIL TRAY, REMOVING AND INSTALLING .
CAUTION:
Risk of damaging the engine by the timing mechanism skipping.
- Only let the engine turn in the direction of engine rotation.
-- Turn the crankshaft using the : T40263 and : T40314 -arrow- until the corresponding oil spray jet is accessible.
-- Mark the installation position and the connecting rod bearing cap allocation to the cylinder and connecting rod for installing again later. Refer to Figure.
-- Remove the corresponding bolts -arrows- and remove the connecting rod bearing cap.
-- Remove the banjo bolt -2- and the oil spray jet -1-.
-- Repeat the procedure if necessary on each oil spray jet.