Overview - Cylinder Block, Transmission Side

WARNING: This page is about a different car, the 2022 Audi Q8, 2021 Audi Q8, 2020 Audi Q8, and 2019 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

For assembly work secure the engine on the engine and transmission holder. Refer to ENGINE, SECURING TO ENGINE AND TRANSMISSION HOLDER .

Fig 1: Exploded View Of Cylinder Block, Transmission Side

Courtesy of AUDI OF AMERICA, LLC

Bolt
- 60 Nm + 90°
- Always replace after removing.
Drive Plate
- With the bearing flange
- Check the contact surfaces on the bearing flange and the torque converter holes for cracks and wear grooves.
- Removing and installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
Sensor Wheel
- For the Engine Speed Sensor -G28-
- Removing and installing. Refer to SENSOR WHEEL, REMOVING AND INSTALLING .
- Checking. Refer to Vehicle Diagnostic Tester and SENSOR WHEEL, CHECKING .
Seal
- For the crankshaft on the transmission side
- Replacing. Refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .
Alignment Pin
Crankshaft
- Overview. Refer to OVERVIEW - CRANKSHAFT .