Drive Plate, Removing And Installing: Installing

WARNING: This page is about a different car, the 2022 Audi Q8, 2021 Audi Q8, 2020 Audi Q8, and 2019 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

If the drive plate was removed or replaced, the sensor wheel function must be checked before installation. Refer to SENSOR WHEEL, CHECKING .
Replace the bolts that were tightened with an additional turn after removing them.

-- Pay attention to the alignment pin when installing the drive plate.

-- Reposition the : 10-201 to tighten the bolts.