Crankshaft, Removing And Installing: Notes
WARNING: This page is about a different car, the 2022 Audi Q8, 2021 Audi Q8, 2020 Audi Q8, and 2019 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Puller - Unit Injector: T10055
- Torx Screw Driver - T25: T10248
- Locking Pin (3 pc.): T40011
- Puller: T40332
- Pull Rod: T40332/1
- Cross Bar: T40332/2
- Threaded Pins: T40332/3
- Adjusting Pin: T40362
Puller : T40332 , Preparing
-- Tighten the pull rod -1- with the bolts -arrows- as shown on the puller cross bar : T40332 .
-- Remove the threaded pins -2- for later assembly of the tool.