Input Shaft 1, Removing And Installing Individually: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Gear set removed. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .

AWD Vehicles

Courtesy of AUDI

For vehicles with AWD, the bearing inner race must be removed before the gear set is disassembled.

-- Remove the circlip -arrow-.

-- Remove the bearing inner race -arrow- using the Two-Arm Puller:VAS 251 001 and Seal Installer - Shaft Seal:T10431/1 .

Courtesy of AUDI

-- Remove the bolt -arrow- and remove the shift forks for 4/6 gear and 5/7 gear together.

Courtesy of AUDI

-- Remove the input shaft 1 from the gear set.

Courtesy of AUDI

CAUTION:

Damage to input shaft 1

When removing the input shaft 1, the 7th gear wheel may already be loosened and can fall.